Heavy Body & Light Body Dental Silicone Impression Material – Made in UK

POLYOXAL LB

Hydrophilic Vinyl Siloxane Impression Material.

Polyoxal is easy to apply for precision dental impression taking.

POLYOXAL LB: LOW VISCOSITY

Double impression technique correcting

material.

Benefits:

• High Stability
• Addition Cure
• Ease of Use
• High Elasticity
• Soft, Easy to mix

IFU

MIXING RATIO:

Equal parts 1:1 (volume or weight) of base and catalyst paste are recommended which although different in colour, have the same consistency, so that an easily controlled homogeneous mix is obtained.

APPLICATION:

Polyoxal LB: Low Viscosity Dosage 1:1

2min.30sec————– 3.00min——- —–4:00.
Holding Time                Remove

in mouth                  from Mouth

Use typically at 23°C. Relative humidity: 50%.Higher temperature shortens these times and lower temperatures lengthen these times.

IMPORTANT: Syringes should be closed immediately after use, with the correct closures. Do not interchange the caps of the tubs. The impression can be poured 1 hour after removal.

STORAGE: Maximum temperature 25°C, relative humidity 50 5%. Do not use after expiry date.

CAUTION: Avoid contact with the eyes. In case of contact occurs wash immediately with plenty of water or use eye-washers. Seek medical advice if necessary. Material may stain clothing.

POLYOXAL HB PUTTY

Hydrophilic Vinyl Siloxane Impression Material

400g Base + 400g Catalyst

POLYOXAL HB PUTTY:

Primary impression material for double impression technique.

• Addition Cure reaction
• Precise/Accurate Impression
• Fast Reaction
• Sets Hard 3-mins
• Complimentary set with Polyoxal LB

Using the separate measuring spoons, dose 1 level scoopful of each and knead for 1 minute to obtain a homogeneous colour.

APPLICATION:

Polyoxal HB: Putty- Dosage 1:1

0 min.————– 1 min.——- —–2 min. 30sec.————- 4 min.——– —- 6 min. 30sec.
Mixing                 Loading                      Holding Time           Remove
Time                    Time                            in Mouth           from Mouth

Mouth

Use typically at 23°C. Relative humidity: 50%.Higher temperature shortens these times and lower temperatures lengthen these times.

IMPORTANT: Latex based rubber gloves should not be used when mixing Polyoxal HB. Tubs and syringes should be closed immediately after use, with the correct closures. Do not interchange the caps of the tubs. The impression can be poured 1 hour after removal.

STORAGE: Maximum temperature 25°C, relative humidity 50 5%. Do not use after expiry date.

CAUTION: Avoid contact with the eyes. In case of contact occurs wash immediately with plenty of water or use eye-washers. Seek medical advice if necessary. Material may stain clothing.